The Auto-couple window is divided into three sections. On the left is a check button labeled "Set All Zones". Below that is the instruction "Single click to add zone to autocouple list", followed by a scrollable list box containing, for this example, the following entries:

• Z01 FBDY1
• Z02 FBDY2
• Z03 FBDY3
• Z04 WINF IB
• Z05 CBDY

In the middle is a button labeled "Unset All Zones". Below that is the heading "Zones currently set for autocoupling", followed by a scrollable list box that, for this example, is empty.

On the right is the instruction "Select type of autocoupling to perform:", followed by two radio buttons labeled "Regular" and "Overlapping". Below that is the instruction "Select autocoupling mode:", followed by two more radio buttons labeled "Auto-couple points with undefined BC" and "Auto-recouple points with coupled BC".

Next is the instruction "Enter a name for the report (leave blank for no report):, followed by an empty text box.

At the bottom are "Auto-Couple" and "Cancel" buttons.